This means you can compress one section of the signal, but still limit the full signal. The compressor can be made parallel, and even used to expand the signal if desired.įurthermore, this compressor can be used to affect the full frequency spectrum, the low range using the low pass filter, or the mid-range using the band-pass filter. So again, this section here, with the threshold, knee, ratio, attack, and release, all have to do with your compressor, not the limiter. The one further to the left is the gain reduction of the compressor, the one on the right is the gain reduction of your limiter. You’ll notice that once you start affecting your threshold, knee, ratio, and so on, that you get 2 different gain reduction meters on the right. Keep in mind that this knee refers to an additional compressor, not your brick wall limiter. If you want, you can see your full frequency response and the knee of your compression. On the right is your output gain, which should be lowered slightly to avoid inter-sample clipping. ![]() The display shows the amount of attenuation, as well as the amplitude of the original and effected signal. ![]() ![]() On the left is your input gain which automatically enables the limiter once increased enough. The cost of the Weiss Compressor/Limiter is $199.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |